Nest was a great company UNTIL they were acquired by Googone, - gle we have unplugged every thing smart except the therm we have AC on a separate manual adjustment.
I'm looking for a thermostat that will continue to run the fan for a few minutes after the A/C compressor shuts off to dry the evaporator coils. Without this, the coil gets musty and I have to take it apart to clean it.
I've got an older Nest that does it, but I'd like to get rid of it.
If you're good with basic electronics, you should be able to wire up a delay relay to do exactly this.
Should be pretty cheap to buy a delay (off) timer from automation direct and just turn the dial to whatever minutes you want. Wiring and knowing which wires do which may be the hardest part.
I was looking into building one using an Arduino, but I also need one for my mother's house that has to be pretty. I know Nest can't be the only ones who thought of this.
If you can arduino you're way more savvy than I expected and you totally can build two delay timers either with an ice cube relay, or fancy pants arduino programming (but then you need to power it, hide the device somewhere, program it, etc) I myself would simply go with the AD.com standalone relay
Try a carrier standard thermostat. We have an older one that has no digital reading. It has the little lever that sticks out the right side of it you slide up and down for temperature control. It works fine. Edit; just wanted to add, I don't think they have our model anymore. They do have standard non smart thermostats.
Nest was a great company UNTIL they were acquired by Googone, - gle we have unplugged every thing smart except the therm we have AC on a separate manual adjustment.
I'm looking for a thermostat that will continue to run the fan for a few minutes after the A/C compressor shuts off to dry the evaporator coils. Without this, the coil gets musty and I have to take it apart to clean it.
I've got an older Nest that does it, but I'd like to get rid of it.
If anyone has any suggestions, please post them.
I could, but fan motors aren't always that efficient.
https://www.usinspect.com/blog/can-running-hvac-fan-continuously-save-energy-costs-part-1-3/
Now I've gone down a rabbit hole learning about small duct high velocity and air to water heat pumps.
https://www.spacepak.com/central-air-heating-and-cooling-system
I've been watching their training and install videos for almost an hour now.
They've got variable speed blower motors and are able to dehumidify outside the cooling cycle.
If you're good with basic electronics, you should be able to wire up a delay relay to do exactly this. Should be pretty cheap to buy a delay (off) timer from automation direct and just turn the dial to whatever minutes you want. Wiring and knowing which wires do which may be the hardest part.
I was looking into building one using an Arduino, but I also need one for my mother's house that has to be pretty. I know Nest can't be the only ones who thought of this.
https://www.instructables.com/Arduino-Thermostat/
I might gut a cheap thermostat and connect the display and buttons to the Arduino.
Have you tried calling your local HVAC place and see what they recommend?
If you can arduino you're way more savvy than I expected and you totally can build two delay timers either with an ice cube relay, or fancy pants arduino programming (but then you need to power it, hide the device somewhere, program it, etc) I myself would simply go with the AD.com standalone relay
Try a carrier standard thermostat. We have an older one that has no digital reading. It has the little lever that sticks out the right side of it you slide up and down for temperature control. It works fine. Edit; just wanted to add, I don't think they have our model anymore. They do have standard non smart thermostats.